User Gage - Punches / Holes

(Revised: 11/19/14)

Punches or Holes can be added to User Gage parts.

Holes

Holes can only be added to Press Break Gage parts.

Check the Punches / Holes box and select the Properties button.

Input the hole location using X Dim & Y Dim (ff/ii/ss).

X Dim is from left edge.

Y Dim is from lower left corner.

Input the Hole Diameter

Add Slot Length & Slot Angle if required.

Select the Insert button to add the holes to the part.

Symmetrical punching cannot be selected for Holes.

Punches
Punches can only be added to Rolled shapes (Zee, Cee, Double Cee & Eave Strut)

Select the Punch Code using the drop down box.

Input the hole location (ff/ii/ss).

All punch codes except (10) will be located symmetrically.

Select the Insert button to add the holes to the part.

Standard Controls:

§ OK, Cancel, Apply, & Help

See also:

§ General - Drag & Drop