User Gage – Welded Subparts
(Revised:
09/21/12)
Welded Subparts can be used
to Insert, Revise or Delete Plates, Clips, and User Clips.
Welded Subparts
Check the Welded Subparts box then select the Properties
button.
The drop list below the Part column is used to select the
Subpart to add.
Any clips created in User Clips will be included in the drop
list.
Subpart location is input in the box below the Distance
column.
►How to use:
Select a subpart from the drop
list.
Input the subpart location from
end of part.
Pick Insert to add subpart.
OK to save and exit.
An Exception Drawing will be required to give Subpart
location and weld requirements.
Standard
Controls:
Limitations:
G30 & G90 material will
not allow Welded Subparts.
See also: