Opening - Description
(Revised: 04/01/08)
This tab is used in
conjunction with the Location tab to create an opening on a wall or roof.
This is a fast way to remove
Panel, Insulation, and / or Secondary from any rectangle or gable shape
opening.
„
Limitation:
This feature is Not Intended
to be used for openings at masonry walls, or panels by others.
These conditions are considered different Covering types and should
be defined at the Covering levels.
Options:
Opening
Name
Enter a unique name for the
opening. This name will be used to identify this opening in the Tree.
Remove
Secondary
Remove the secondary from the
opening.
Extend
Secondary to Frames Inside the Opening / Maximum Dimension
Define the maximum distance
the secondary can project into the opening to connect to a frame line.
„
Sample:
Remove
Covering (Add Trim)
Remove the panels from
opening.
The panel will only be cut if
the entire Panel width is inside the opening you have defined.
Remove
Insulation
Remove the insulation at from opening.
The insulation run will only
be cut if the entire insulation width is inside the opening you have defined.
Remove
Liner
Remove the liner panels from
opening.
The liner panel will only be
cut if the entire panel width is inside the opening you have defined.
Standard
Controls:
See also: